How to make "Observe Table"

    Before observations with the ASTE 10m telescope, you must prepare "Observe Table" which consists of three subtables ("Source Table", "Scan Table", and "Device Table") and send it to the workstation which controls the ASTE 10m telescope system. You can make these subtables and send "Observe Table" to the workstation by using a software "Obstable". This manual explain how to use "Obstable" and about the parameters which you have to enter.
 

Contents

1. Preparation
2. How to use Obstable
• Startup Obstable
• Preparation of Source Table, Scan Table, and Device Table
• Preparation of Observe Table
• Basic operation
3. Parameters of Source Table
• (RA,DEC) or (L,B)
• (Az,El)
• Solar object
4. Parameters of Scan Table
• Line observation
• Continuum observation
5. Parameters of Device Table
• Line observation (MAC)
• Line observation (WHSF)
• Continuum observation